| Article number: | RG0008/1510-4-AF-12 |
| Availability: | In stock (100) |
| Delivery time: | 5-10 business days |
Tranemo RG0008 Gloves 1510-4 Heat AF-12 Waterproof
Flame retardant waterproof glove with high protection against Electric Arc and high cut resistance (Eureka 1510-4HAF-12-WP) Optimized for high category arc flash risks. Perfect in tough working conditions with high temperatures, flames and the risk of an electric arc. High performance in cut resistance. Available per pair.
Properties:
- Eureka article: 1510-4 Heat AF-12 Waterproof
- Material: para-aramid, fiberglass, chloroprene composite
- Standards: EN 407 42424X, EN 388 2X43D, ANSI CUT A4, ASTM F2675 ATPV 12 cal/cm²
- Cut resistant: A4, D
- Sizes: 7/XS - 12/XXL
- Color: 00 multi-color
- Available: per pair
- Packing: 12 pcs/pack, 5 pack/carton
Standardization:
EN 407 42424X STANDARD. HEAT AND/OR FIRE
Gloves that provide protection against thermal hazards (heat and/or fire).
Heat resistant gloves that have been tested and certified according to EN 407:2004 are labeled with the following pictogram.
The nature and degree of protection of the heat-resistant gloves is indicated in six protection areas, namely:
(A) Fire behavior (performance level 0 - 4)
(B) Contact heat (performance level 0 - 4)
(C) Convective heat (performance level 0 - 4)
(D) Radiant heat (performance level 0 - 4)
(E) Small splashes of molten metal (performance level 0 - 4)
(F) Large splashes of molten metal (performance level 0 - 4)
EN 388 2X43D STANDARD. MECHANICAL RISKS
Protection against physical and mechanical hazards due to abrasion, cutting, perforating and tearing.
The protection against mechanical hazards is indicated by a pictogram followed by four numbers (performance levels) where each number corresponds to the test results for a specific risk:
a.Abrasion resistance
based on the number of cycles required to abrade through the glove sample.
b. Cut resistance
based on the number of cycles required to cut through the glove sample at a constant speed.
c. Tear resistance
based on the force required to tear the glove sample.
d. Puncture resistance
based on the force required to pierce the glove sample with a standard size tip.
ANSI CUT A4 STANDARD. AMERICAN STANDARD FOR CUT RESISTANCE
In addition to the European standard, Eureka uses the ANSI test for cut resistance. This is to achieve a higher result range, A1-A9. The result is given in Newtons. The test methods are the same as those in EN388.
ASTM F2675 ATPV 12 cal/cm² STANDARD. ATPV VALUE FOR PROTECTIVE GLOVES
Protective gloves tested to ASTM F2675 - performed to determine a glove's Arc Rating (ATPV or EBT).